its not really hard when you have all programms you need for it. but the problem is the machine and the programm for the machine. the laser-machine alone cost more than 15.000 euro. (a good one, with lasering and cuting and multifunction.) and the programm about 2000-3000 euro. thats the only one problem for it. but its quite easy and every one can do this (when you've got the machine for it ).

first you need a picture, than change it a bit, right format, right size and and and, then you need plexiglas and now the machine. you give the plexiglas inside in the machine and (becareful!) you must give it on the right place, or your pic will be destroyed. you start the programm and give your pic with the right size on it, (the programm must be installed with the machine and it is also the start and stop button for it)you must change some setups, et voila, start it. but you must look the whole process on the programm and on the machine, because sometimes (not sometimes, mostly) there will be go something wrong. burning or cuting the whole pic.

and finish, the only hard thing are those programms to use it, and you must look all the time, to stop quick in case of any problems.

its easy

but it will be more beautiful when you got the lights for it. those LED-lights. i must buy one (12 euro, not bad). but i dont know wich colour. blue, or maybe other colours?